making input images for darktable-chart
To start with, you need a suitable photo of your color reference card in RAW+JPEG format. It goes beyond the scope of this manual to explain the details of how to take this photo, but in a nutshell you need to make the shot on a sunny day around midday with the light source (the sun) shining at an angle onto the card. You need to avoid any glare in the image. The neutral white color patch in the gray ramp (G00) should end up at the L value specified in the description of your card. Often this is L=92 and requires you to overexpose the shot by about 1/3 EV. Ideally you will make several shots with slightly different exposures and later select the right one in darktable. Make sure that the chart fills up most of the frame. Use a lens with a “normal” focal length (e.g. 50mm equivalent) and stop down a bit to avoid vignetting.
You then open the raw file in darktable and disable most modules, especially base curve. Select the standard input matrix in the input color profile module and disable gamut clipping. Select “camera white balance” in the white balance module.
There is a special situation if your camera automatically applies some lens corrections (namely vignetting correction) to the resulting JPEG file. In this case you need to activate the lens correction module in darktable so that raw processing matches the JPEG in this respect. However, since darktable’s vignetting correction may not exactly match the in-camera correction, it is better to disable this correction in-camera if possible.
To output your image go to the export module in the lighttable.
You will need to select “Lab” as the output color profile. This color space is not visible in the combobox by default. You first need to enable it by setting
$HOME/.config/darktable/darktablerc. Alternatively, you can start darktable with:
darktable --conf allow_lab_output=true
Then select “PFM (float)” as the output format and press “export” to generate the source image file.
You can produce the corresponding reference (target) image from the JPEG in a similar way. This time you will need to disable all modules and export with the “Lab” output color profile in “PFM (float)” format.
- German (translation incomplete): Eingabebilder für den dartable-Chart erstellen
- Polish (translation incomplete): tworzenie zdjęć wejściowych dla darktable-chart
- Português (translation incomplete): criar imagens de entrada para o darktable-chart
- Ukrainian (translation incomplete): створення вхідних зображень для darktable-chart
- Dutch (translation incomplete): invoerafbeeldingen maken voor darktable-chart